FDF RaceShop GRASSROOTS PERFORMANCE BRZ/FRS/GT-86 COILOVERS without Mantis Angle Kit

32 stages of dampening to dial in your driving style and vehicle response. Even at low ride height setups, this is reliability without sacrificing your ride quality. "Type 1" coilovers help maximize your stance with full-bodied adjustable bottom mount. A perfect match to your new Angle Kit or Brake Kit.

FITS ALL 2013+ Models

Recently featured in the "Performance Auto & Sound" SEMA 2018 Issue. View the feautured article here.

1 Year Replacement Warranty

SPECS
Track Enthusiast Level
Mono Tube Construction
Custom Spring rates are available upon request
45MM Pistons
7K Front 6K Rear spring rate
32 Stages of Dampening Levels
Allen Key Dampening Control
Full Body Height Adjusting
Anodized & Powder coated components
Track tested & approved
For 2013+ Models
SAVE $200 when you purchase with the FDF FRS / BRZ Mantis Angle Kit

The "BASE KIT" includes the following

-Custom knuckles
(50mm roll center corrected, adjustable ackerman, 40%weight reduction, double shear spherical bearing pick up and added trail to work with the reduced caster)
- Lower control arms
(adjustable in length and caster, these lower control arms reach out to +75mm over stock length)
- Outer Tierods (sperical bearing outer ball joint with 2024 aluminum adjuster)
-Caster plates (new plates for your coilover top that moves the top of the coilover out as far as legally possible, and reduces caster for less bind, less camber gain through lock, and better contact patch during drift)
-All hardware required for install

The "FULL KIT" includes these additional pieces to the base kit

-Inner Tierods
-adjustable offset rack spacer (an offset rack spacer that allows for a spherical bearing to be used, and offers adjustable setting for rach offset)
-weld on plates for subframe (instructions included in purchase of kit)

The "POWER KIT" includes these additional pieces

this kit is in development to implement the s-chassis power steering rack for hydraulic power steering.

-steering rack weld in mounts
-subframe braces
-different knuckles to suit the changed rack location